1. There are many material residues and the scraping is not clean: the original pressed scraper is still used. The horizontal upper knife edge is easy to accumulate material, the knife surface is directly bent, and the scraper's own weight is too light, resulting in a lot of material residue on the disk surface, especially Materials with high density are more difficult to scrape. Zhengzhou Desen Environmental Factory uses thick steel plates to stand up and hand welded, and the vertical plate surface is punched and looped on the rake arm for more flexible rotation. The two steel plates are supported by round steel, and the knife surface is equipped with a PTFE plate and heavy iron is added according to the density of the material, so that the knife and the disc surface have a high degree of coincidence, thereby solving the problem of disc area material.
2. The disc surface is uneven: Desen Environment believes that the disc surface is welded with the upper disc surface in the form of bulging bubbles, which not only strengthens the upper surface but also has the effect of dividing and evenly distributing the heat source inside, which is a good solution. problem. In addition, the outer retaining ring on the large disk surface and the inner blanking ring on the small disk surface are welded and formed after reinforcement of steel plates. The upper edge of the large disk is pressed into an arc, and the small disk surface is pressed down into an arc, which greatly strengthens the rigidity of the disk surface and also makes the surface more flat.
In addition, it is necessary to clean the exhaust pipe and elbow of the disc dryer regularly. If it is not cleaned for a long time, it will easily lead to accidents such as fire. Therefore, the dryer must be cleaned and repaired regularly.https://www.stordworkshop.com/
