First of all, for the newly purchased paddle dryer, we must carry out the correct and standardized installation and conduct a trial operation of the equipment for no less than 4 hours. After the trial operation of the paddle dryer is completed, under the condition that there is no abnormal phenomenon, tighten the joints of the screws and bolts and other parts again, and check to make up the lubricant.
Then, when we preheat the paddle dryer and hot blast stove, we must prohibit the violent fire to prevent the paddle dryer barrel from being unevenly heated and causing serious damage. In the drying process of the material, the moisture content of the material and the speed of the feed are important factors that affect the drying quality and heat consumption of the material. Therefore, we must pay attention to the standard operation method so that the material drying equipment can perform Best working performance.
Third, when the paddle dryer is in operation, pay attention to the timely and quantitative lubricating oil addition to each lubrication point to enhance the better lubrication effect between the friction parts and ensure the flexibility of the accessories Effectively extend the replacement cycle of accessories.
Fourth, during the material drying process, ensure the stability of the voltage, because if the voltage is unstable, it will not only affect the output and quality of the paddle dryer, but also cause irreparable damage to the equipment in severe cases. At the same time, once there is a sudden power failure during the operation of the paddle dryer, we must extinguish the hot blast stove in time, stop feeding, and rotate the barrel half a circle every 15 minutes until the barrel cools.
