1. After the operation of the disc dryer is completed, the temperature regulator should be asked to adjust the position of 0 degrees to reduce improper startup and prolong the service life of the solenoid valve.
2. The temperature setting of the disc dryer should be set according to the drying conditions of the object to be dried, so as to avoid shrinkage of the object to be dried.
3. Before each use of the disc dryer, the cotton wool filter must be cleaned. If the filter is blocked due to improper cleaning, the air volume will decrease, the drying speed will be extremely slow, and the drying effect will be poor. , It will waste a lot of resources.
4. If only part of the dry-cleaned clothes are to be dried, the residual agent on the drying material must be completely volatilized before being put into the disc dryer.
5. In normal use, the carbon powder (black) on the gas stove must be cleaned out every week to prevent it from being sucked into the drum and contaminating the clothes.
6. Regularly remove the foreign matter of cotton residue on the temperature sensor. When the temperature difference between the temperature regulator and the thermometer is found to be too large, it is generally about 5 degrees. cotton.
7. The time setting of the "cold air" timer is usually about 1/4 of the time of the "hot air" timer.
8. Grease must be added to the bearing seat every month to ensure that the bearing has always been lubricated.
9. The exhaust pipes and elbows must be cleaned once a month. If they are not cleaned in time, the drying time will be prolonged, which will cause a fire due to excessive cotton wool blockage.
