Composition of sludge dryer

1. In the guide area, the wet sludge enters this area and quickly evaporates water in contact with the high-temperature hot air. The material will be led to the next working area if it is not bonded under the large guide angle of the copy board; 2. The discharge area, The drum does not have a copy board in this area, and the material rolls and slides to the discharge port to complete the entire drying process; 3. In the cleaning area, the wet sludge is picked up by the copy board in this area to form a material curtain. When the material falls, it is easy to form stickiness. In this area, because the equipment is designed with a cleaning device, the cleaning device can clean the materials adhering to the inner wall very reasonably. In this process, the cleaning device also has a crushing effect on the agglomeration of the material balls, thereby increasing The heat exchange area increases the drying rate. Fourth, the inclined lifting plate area, where the wet sludge is already in a low-moisture loose state, the material has no adhesion phenomenon in this area, and the material reaches the required level after heat exchange The moisture state enters the final discharging area.https://www.stordworkshop.com/