1. The materials to be dried should be loose and not agglomerated, and paste-like materials need to be pre-dried;
2. The performance of the feeder should be excellent to achieve uniform and continuous feeding;
3. It is strictly forbidden to put in hard lumpy materials with a particle size of more than 10mm;
4. The material shall not stick to the surface of the drying plate, otherwise it will affect the heat transfer and blanking effect, and also increase the power consumption;
5. If there is a shutdown due to a power outage or malfunction, you need to stop feeding, heating and water in time, then turn off the power, open the inspection door, and clear the material in the tray to avoid material clumping and crusting on the surface;
6. The distance between the scraper on the feed tray and the feed tray and whether the harrow arm needs to be sleeved and rolled should be determined according to the trial production situation;
7. It is forbidden to reverse the equipment to prevent damage to the equipment;
8. When adjusting the rake blades, be sure to turn off the motor and use manual cranking to adjust. It is forbidden to adjust when the equipment is running to avoid personal injury;
9. The steam pipeline needs to be installed with pressure limiting equipment to prohibit overpressure.
